Set mgmt wwnstate – HP Command View for Tape Libraries Software User Manual
Page 211
Availability
All users and modes
Operands
Specify the time zone number that corresponds with the list that
appears. This operand is required.
zone
Examples
To change the Interface Manager card time zone to that for Denver, Colorado:
/>set mgmt timezone
Number Timezone Number Timezone
------ ---------------------------- ------ ----------------------------
63 America/Belize 94 America/Goose_Bay
64 America/Boa_Vista 95 America/Grand_Turk
65 America/Bogota 96 America/Grenada
66 America/Boise 97 America/Guadeloupe
67 America/Buenos_Aires 98 America/Guatemala
68 America/Cambridge_Bay 99 America/Guayaquil
69 America/Cancun 100 America/Guyana
70 America/Caracas 101 America/Halifax
71 America/Catamarca 102 America/Havana
72 America/Cayenne 103 America/Hermosillo
73 America/Cayman 104 America/Indiana/Indianapolis
74 America/Chicago 105 America/Indiana/Knox
75 America/Chihuahua 106 America/Indiana/Marengo
76 America/Cordoba 107 America/Indiana/Vevay
77 America/Costa_Rica 108 America/Indianapolis
78 America/Cuiaba 109 America/Inuvik
79 America/Curacao 110 America/Iqaluit
80 America/Danmarkshavn 111 America/Jamaica
81 America/Dawson 112 America/Jujuy
82 America/Dawson_Creek 113 America/Juneau
83 America/Denver 114 America/Kentucky/Louisville
84 America/Detroit 115 America/Kentucky/Monticello
85 America/Dominica 116 America/Knox_IN
86 America/Edmonton 117 America/La_Paz
87 America/Eirunepe 118 America/Lima
88 America/El_Salvador 119 America/Los_Angeles
89 America/Ensenada 120 America/Louisville
90 America/Fort_Wayne 121 America/Maceio
91 America/Fortaleza 122 America/Managua
92 America/Glace_Bay 123 America/Manaus
93 America/Godthab 124 America/Martinique
Enter the timezone number to select a timezone, 'm' to print more possible
timezones or 'q' to quit without selecting a timezone [default = 'm']: 83
Committing configuration...done
See also
set mgmt wwnstate
Description
Sets the World Wide Name (WWN) retention state for the Interface Manager
card. All WWN information shown is for the node name/ID. This command
is deprecated. For more information, see
.
NOTE:
In Command View TL versions 2.0 and later and Interface Manager
I200 and later the WWN retention state feature is always enabled.
Syntax
set mgmt wwnstate [enabled] | [disabled]
Availability
All users and modes
Operands
Specify whether to enable or disable the
WWN retention state. This operand is
required.
[enabled] | [disabled]
Examples
To enable the WWN retention state of the Interface Manager card:
/>set mgmt wwnstate enabled
See also
set interface clearwwnmismatch
set mgmt wwnstate
211