Viewing – HP Command View for Tape Libraries Software User Manual
Page 121
NOTE:
If the data verification partition is modified from the Library Management Console, you
must restart the data verification service to reflect the changes in the Test Setup Details screen.
Ensure that all drives assigned are not loaded with tapes before starting the service.
If the data assessment results are poor or fair, an email notification is sent. To configure email
notifications for data verification, see
“Setting up data verification email notifications” (page 126)
.
You can run a maximum of six drive assessment tests, data verification tests, or a combination of
both at one time.
Viewing tapes that are present in the data verification partition
The Tapes in Partition section of the Test Setup Details screen lists the tapes present in the data
verification partition.
A warning symbol next to the barcode in this window means the tapes are not supported by data
verification. See
for compatible tapes.
You can use the Tapes in Partition window to mark known good tapes for use with the drive
assessment test:
1.
Select the tapes known to be good; use Ctrl+select to select multiple tapes at a time.
2.
Click the Mark/Unmark button (
) on the app bar. A confirmation/warning box appears.
3.
Click OK.
Click the linked previous verification result to see the details of the last verification test.
Using data verification
121