HP Command View for Tape Libraries Software - Manual (Page 228)

Operands Displays whether the ftp service is enabled or disabled. ftp
telnet Displays whether the telnet service is enabled or disabled.
tlogin Displays whether the rlogin service is enabled or disabled.
all Displays whether the ftp, telnet, and rlogin services are
enabled or disabled.
Examples To show whether the rlogin service is enabled or disabled::
/>show inet rlogin
rlogin is Disabled
To show whether ftp, telnet, and rlogin are enabled or disabled::
/>show inet all
ftp is Enabled
telnet is Enabled
rlogin is Disabled
See also set inet ftp
set inet telnet
show interface access
Description Shows access information at the interface level. This command lists all tape
drives connected to the specified interface. For each tape drive listed, the
command shows which hosts have access to it, and the target LUN giving the
host access to the drive.
Syntax show interface access [interface_num] | [all]
Availability All users and modes
Operands Specify the interface for which to display access
information. The access information may be displayed interface_num
for all interfaces by specifying all for this operand.
This operand is required.
Examples To show interface access information for interface 1:
/>show interface access 1
Interface access information:
Interface 1 tape drives:
Access information for drive 1:
Host Host Name WW Node Name LUN Port
-------- ---------------------- -------------------- ----
1 myhost1 FFFFFFFFFFFFFFFFFFFF 1 1
See also show drive access
show interface beacon
Description For HP StorageWorks e2400-4Gb FC interface controllers, shows whether
the beacon is currently on or off.
Syntax show interface beacon [interface_num] | [all]
Availability All users and modes
Operands Specify the interface for which you want to show the
beacon state. The beacon state may be displayed for interface_num
all interfaces that have beacons by specifying all for
this operand. This operand is required.
Examples To show the state of the beacon on interface 3:
/>show interface beacon 3
Interface 3 beacon: Off
To show the state of the beacons on all interfaces:
/>show interface beacon all
228 CLI Command Reference