Changing management station passwords – HP Command View for Tape Libraries Software User Manual
Page 34
started; the current GUI is unaffected. This value can be viewed in the content pane of the
Management Station tab.
5.
Set the host name or active IP address for the management station. The active IP address is
the one used by the management station to communicate with clients and libraries.
NOTE:
It is important to verify that the correct host name or IP address is set. On dual
networked servers, the installation process may have chosen the wrong IP address.
6.
Click OK to save your changes.
NOTE:
Changing the host name or active IP address terminates the current GUI session. To
restart the GUI session, enter the new active IP address in the address field of the browser.
Changing management station passwords
IMPORTANT:
Each user has a password (see
). Default passwords are set at the factory.
For security reasons, you should always change these passwords.
To change the password for the Command View TL management station:
1.
In the Launcher window, click the Administration tab.
2.
Select Actions
→Change password. The Change Password dialog box appears.
3.
Enter the current password, new password, and confirm the new password. Also enter a
security question and answer that can be used to recover the password if you forget it in the
future.
34
Command View TL GUI