HP Color LaserJet 4700 Printer series User Manual
Page 204
Control panel message
Description
Recommended action
41.3 UNEXPECTED
SIZE IN TRAY X
For help press
alternates with
LOAD TRAY XX
[TYPE] [SIZE]
To use another
tray press
Media is loaded that is longer or shorter in the
feed direction than the size configured for the
tray.
1.
If the incorrect size was selected, cancel
the job or press to access help.
OR
2.
Press to select another tray.
3.
Press and to step through the
instructions.
41.5 UNEXPECTED
TYPE IN TRAY X
For help press
alternates with
LOAD TRAY XX
[TYPE] [SIZE]
To use another
tray press
The printer senses a different media type in
the media path than configured in the tray.
1.
If the incorrect type was selected,
cancel the job or press to access help.
OR
2.
Press to select another tray.
3.
Press and to step through the
instructions.
44.1 USB ACCESSORY
ERROR
For help press
This message appears when a connected
USB accessory draws too much power.
When this happens, the ACC port is disabled
and printing stops.
Press to see step by step information.
49.XXXX
PRINTER ERROR
To continue
turn off then on
A critical firmware error has occurred.
1.
Turn the printer off then on.
2.
If the message persists, contact
HP Support at
50.X FUSER ERROR
For help press
A fuser error has occurred.The following are
specific fuser errors:
50.1: A low fuser temperature error has
occurred in the main thermistor.
50.2: A fuser warm-up service error has
occurred.
50.3: A high fuser temperature error has
occurred in the main thermistor.
50.6: An open fuser error has occurred.
50.7: A fuser pressure release mechanism
failure has occurred.
1.
Turn the printer off then on.
2.
Press and to step through the
instructions.
3.
If the message persists, contact
HP Support at
188
Chapter 8 Problem solving
ENWW