HP Color LaserJet 4700 Printer series - Manual (Page 92)

RAM disk
This option allows you to specify how the RAM disk is configured. Options are AUTO and OFF. When
set to AUTO, the printer determines the optimal RAM size based on the amount of available memory.
The message displays only in printer models that do not have a hard disk installed. The default is AUTO.
Changing RAM disk behavior
You can change this behavior at any time by following these steps:
1. Press Menu to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight SYSTEM SETUP.
5. Press to select SYSTEM SETUP.
6. Press to highlight RAM DISK.
7. Press to select RAM DISK.
8. Press or to select AUTO or OFF.
9. Press to set the selection.
10. Press Menu .
Language
On some products, the option to set the default language appears when the printer is first initialized.
Use the or arrow to scroll through the available options. When the desired language is highlighted,
press the to set the default language. The default language is ENGLISH.
You may also change the language at any time by following these steps:
Selecting the language
1. Press Menu to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight SYSTEM SETUP.
5. Press to select SYSTEM SETUP.
6. Press to highlight LANGUAGE.
7. Press to select LANGUAGE.
8. Press or to select the appropriate language.
9. Press to set the selection.
10. Press Menu .
76 Chapter 2 Control panel ENWW