The hp all-in-one will not turn on – HP Photosmart C6280 All-in-One Printer User Manual
Page 114
The HP All-in-One will not turn on
Cause: The HP All-in-One is not properly connected to a power supply.
Solution:
•
Make sure the power cord is firmly connected to both the HP All-in-One and the
power adapter. Plug the power cord into a grounded power outlet, surge protector,
or power strip.
1 Power connection
2 Power cord and adapter
3 Grounded power outlet
•
If you are using a power strip, make sure the power strip is on. Or, try plugging
the HP All-in-One directly into a grounded power outlet.
•
Test the power outlet to make sure it is working. Plug in an appliance that you
know works, and see if the appliance has power. If not, then there might be a
problem with the power outlet.
•
If you plugged the HP All-in-One into a switched outlet, make sure the switch is
on. If it is switched to on but still does not work, then there might be a problem
with the power outlet.
Cause: You pressed the On button too quickly.
Solution: The HP All-in-One might not respond if you press the On button too
quickly. Press the On button once. It might take a few minutes for the HP All-in-One
to turn on. If you press the On button again during this time, you might turn the device
off.
CAUTION:
If the HP All-in-One still does not turn on, it might have a mechanical
failure. Unplug the HP All-in-One from the power outlet and contact HP. Go to:
If prompted, choose your country/region, and then click
Contact HP for information on calling for technical support.
Hardware setup troubleshooting
113
Trou
bles
ho
ot
ing