HP Photosmart C6280 All-in-One Printer - Manual (Page 16)

4 Finish setting up the HP All-in-
One
After you have completed the steps in your Setup Guide, refer to this section to help you
finish setting up the HP All-in-One. This section contains important setup-related
information for your device, including information on setting preferences.
This section contains the following topics:
• Set your preferences
• Computer connection information
• Connect to a network
Set your preferences
You can change the settings on the HP All-in-One so that it behaves according to your
preference. For example, you can set general device preferences, such as the language
used to display messages. You can also restore the device settings to what they were
when you purchased your device. This will erase any new defaults you have set.
This section contains the following topics:
• Set your language and country/region
• Set the default paper tray for DPOF printing
• Enable faster browsing of photos
• Restore the factory defaults
• Play a slideshow on the display
Set your language and country/region
The language setting determines which language the HP All-in-One uses to show
messages on the display. The country/region setting determines the default paper sizes
and layouts for printing. You can change these settings at any time by using the following
procedures.
To set your language
1. Press Setup.
2. Press to highlight Preferences, and then press OK.
3. Press to highlight Set Language, and then press OK.
4. Press to scroll through the languages. When the language you want to use
appears, press OK.
5. When prompted to confirm the language, press to highlight Yes or No, and then
press OK.
To set your country/region
1. Press Setup.
2. Press to highlight Preferences, and then press OK.
Finish setting up the HP All-in-One 15
Finish
set
up