The hp all-in-one prints meaningless characters, Nothing happens when i try to print – HP Photosmart C6280 All-in-One Printer User Manual

Page 135

Advertising
background image

Solution: The printer driver status might have changed to either offline or stop
printing
.

To check the printer driver status

1.

In the HP Solution Center, click the device tab.

2.

Click Settings.

3.

Click Status.
If the status is offline or stop printing, change the status to ready.

Cause: A deleted print job is still in the queue.
Solution: A print job might remain in the queue after it has been cancelled. The
cancelled print job jams the queue and prevents the next print job from printing.
From your computer, open the printer folder and see if the cancelled job remains in
the print queue. Try to delete the job from the queue. If the print job remains in the
queue, try one or both of the following:

Disconnect the USB cable from the HP All-in-One, restart the computer, and then
reconnect the USB cable to the HP All-in-One.

Shut down the HP All-in-One, restart the computer, and then restart the HP All-
in-One.

Cause: The Two-sided printing accessory is not installed correctly.
Solution: If the Two-sided printing accessory is installed, remove it and reinstall it.
To reinstall it, press the buttons on each side of the accessory and push it into the
rear of the HP All-in-One until it clicks into place.

If the Two-sided printing accessory is not installed, install it at the rear of the HP All-
in-One.

The HP All-in-One prints meaningless characters

Cause: There is no more available memory in the HP All-in-One.
Solution: Turn off the HP All-in-One and your computer for 60 seconds, then turn
them both on and try printing again.

Cause: The document is corrupt.

Solution: Try printing another document from the same software application. If this
works, then try printing a previously saved version of the document that is not corrupt.

Nothing happens when I try to print

Cause: The HP All-in-One is turned off.
Solution: Look at the On button located on the top of the HP All-in-One. If it is not
lit, the HP All-in-One is turned off. Make sure the power cord is firmly connected to

Chapter 14

134

Troubleshooting

T

roub
les
hoot

ing

Advertising