Wired network setup, What you need for a wired network – HP Photosmart C6280 All-in-One Printer User Manual
Page 20
If you want to:
See this section:
Change the HP All-in-One from a USB
connection to a network connection.
NOTE:
Use the instructions in this section if
you first installed the HP All-in-One with a USB
connection, and you now want to change to an
Ethernet network connection.
“Change the HP All-in-One from a USB
connection to a network connection”
on page 22
View or change the network settings.
“Manage your network settings” on page 22
Find definitions of networking terms.
Find troubleshooting information.
“Network troubleshooting” on page 120
Wired network setup
This section describes how to connect the HP All-in-One to a router, switch, or hub using
an Ethernet cable and how to install the HP All-in-One software for a network connection.
This is known as a wired or Ethernet network.
To set up the HP All-in-One on a wired
network, you need to do the following:
See this section:
First, collect all of the required materials.
“What you need for a wired network”
on page 19
Next, connect to a wired network.
“Connect the HP All-in-One to the network”
on page 20
Finally, install the software.
“Install the software for a network connection”
on page 21
What you need for a wired network
Before you connect the HP All-in-One to a network, make sure you have all of the required
materials.
(continued)
Connect to a network
19
Finish
set
up