HP Deskjet F4240 All-in-One Printer - Manual (Page 29)

4. Insert the stack of paper into the input tray with the short edge forward. Ensure that
the side you want to print on faces down. Slide the stack of paper toward the product
until it stops.
CAUTION: Make sure that the product is idle and silent when you load paper
into the input tray. If the product is servicing the print cartridges or otherwise
engaged in a task, you could push the paper too far forward, causing the product
to eject blank pages.
TIP: If you are using letterhead, insert the top of the page first with the side you
want to print on facing down. For more help on loading full-size paper and
letterhead, refer to the diagram engraved in the base of the input tray.
5. Slide the paper-width guide inward until it stops at the edge of the paper.
Do not overload the input tray; make sure the stack of paper fits within the input tray
and is no higher than the top of the paper-width guide.
Load photo paper
You can load up to 216 x 279 mm (8.5 x 11 inch) photo paper into the input tray of the
product. For best results, use HP Advanced Photo Paper.
TIP: To help prevent rips, wrinkles, and curled or bent edges, store all paper flat in
a resealable bag. If the paper is not stored properly, extreme changes in temperature
and humidity might result in curled paper that does not work well in the HP All-in-One.
Chapter 6
26 Load originals and load paper
Load
origina
ls
a
nd
load
pa
per