HP Color LaserJet 4730 Multifunction Printer series - Manual (Page 107)

3. If the highlighted size is not correct, touch X.XxX.X INCHES or X MILLIMETERS . Then use the
numeric keypad to set the X and Y dimensions.
4. If the highlighted paper type is not correct, touch PAPER HANDLING and select the paper type.
5. Touch OK .
6. Touch EXIT .
Configuring trays using the Paper Handling menu
You can also configure the trays for type and size without a prompt from the MFP. Use the PAPER
HANDLING menu to configure the trays as follows.
Configuring the paper size
1. At the control panel, press Menu .
2. Touch PAPER HANDLING .
3. Touch TRAY <N> SIZE . (N represents the number of the tray you are configuring.)
4. Touch SIZE . If you select CUSTOM , go to step 5.
5. Touch ? or X MILLIMETERS . Then use either the numeric keypad or scroll bars to set the X
dimension. Press OK and then set the Y dimension.
6. Touch OK .
7. Touch EXIT .
Configuring the paper type
1. Press Menu .
2. Touch PAPER HANDLING .
3. Touch TRAY <N> TYPE . (N represents the number of the tray you are configuring.)
4. Touch the paper type.
5. Touch EXIT .
Configuring Tray 2, 3, or 4 for a custom paper size
The MFP automatically detects many sizes of paper, but you can also configure trays for custom paper
sizes. You must specify the following parameters:
● Unit of measure (millimeters or inches)
● X dimension (the width of the page as it feeds into the MFP)
● Y dimension (the length of the page as it feeds into the MFP)
ENWW Configuring input trays 87