HP Color LaserJet 4730 Multifunction Printer series User Manual
Page 36
If the welcome screen does not open, start it by using the following procedure:
●
On the Start menu, click Run.
●
Type the following: X:\setup (where X is the letter of the CD-ROM drive).
●
Click OK.
5.
When prompted, click Install Printer and follow the instructions on the computer screen.
6.
Click Finish when installation has completed.
7.
You might need to restart the computer.
8.
Print a Test Page or a page from any software program to make sure that the software is correctly
installed.
If installation fails, reinstall the software. If this fails, check the installation notes and Readme files
on the MFP CD-ROM or the flyer that came in the MFP box, or go to
for help or more information.
To set up a Windows computer to use the network MFP using Windows-sharing
If the computer will print directly to the MFP, you can share the MFP on the network so that other network
users can print to it.
See your Windows documentation to enable Windows-sharing. After the MFP is shared, install the MFP
software on all computers that share the MFP.
Installing the software after the parallel or USB cable has been connected
If you have already connected a parallel or USB cable to a Windows computer, the New Hardware
Found dialog box appears when you turn on the computer.
To install the software for Windows 98 or Windows Me
1.
In the New Hardware Found dialog box, click Search CD-ROM drive.
2.
Click Next.
3.
Follow the instructions on the computer screen.
4.
Print a Test Page or a page from any software program to make sure that the software is correctly
installed.
If installation fails, reinstall the software. If this fails, check the installation notes and readme files
on the MFP CD-ROM or the flyer that came in the MFP box, or go to
for help or more information.
To install the software for Windows 2000 or Windows XP
1.
In the New Hardware Found dialog box, click Search.
2.
On the Locate Driver Files screen, select the Specify a Location check box, clear all other check
boxes, and then click Next.
3.
Type the letter for the root directory. For example, X:\ (where "X:\" is the letter of the root directory
on the CD-ROM drive).
16
Chapter 1 MFP basics
ENWW