ATEN CN-5000 - Manual (Page 101)

Method 2: (For a fixed IP address)
A fixed IP address can also be assigned with the ARP command as follows:
1. If the CN-5000 is powered on, Power it off by unplugging its power
adapter cable.
2. Run the ARP command with the following arguments:
arp -s <desired ip address> <CN-5000’s MAC address>
Where the IP address that you assign is one suitable for the network
segment that the CN-5000 resides on.
Note: The CN-5000’s MAC address can be found on its bottom panel.
3. Power on the CN-5000
4. From your browser, log into the CN-5000 using the IP address you just
assigned.
Note: You must do this within 30 seconds of powering the CN-5000 on.
2005-09-13
Appendix
89