ATEN CN-5000 - Manual (Page 65)

Uploading Changes
When the Settings have been configured to your satisfaction and you are
ready to upload the changes to the CN-5000:
1. If you made changes on the Network page, or if you upgraded the
firmware on the Customization page, you must enable Reset on Exit (see
p. 62) before going to step 2.
2. Click OK (at the bottom of the Settings notebook), to start the updating
procedure.When updating has finished, the following message displays:
3. Click OK and you return to the Administration Utility device selection
window (see p.26 ).
Note: To abandon the changes you made and return the settings to the
values they had before you ran the Utility, Click Cancel.(at the
bottom of the Settings notebook) instead of OK in step 1.
2005-09-13
8. AP Operation
53