ATEN CN-5000 - Manual (Page 38)

Customization
This configuration dialog allows the Administrator to set Timeout, Login failure,
and Working mode parameters.
An explanation of the Customization parameters is given in the table below:
Time out Control If the CN-5000 doesn’t receive any input from a computer that is
accessing it with the Windows or Java client for the amount of
time specified here, it ends the connection.
Login failure Login failures allowed, sets the number of consecutive failed
login attempts that are permitted from a remote computer.
Login failure timeout, sets the amount of time a remote
computer must wait before attempting to login again after it
has exceeded the number of allowed failures.
Working Mode If Stealth Mode is enabled, the CN-5000 cannot be pinged. If
Echo Mode is disabled, the CN-5000 will not show up in the list
of local CN-5000 units when accessing it with the AP program.
See p. for details.
Multiuser
Operation Enabling Multiuser operation permits more than one user to
log into the CN-5000 at the same time.
Reset on exit Placing a check here causes the CN-5000 to reset itself and
implement all the new changes when you log out. A wait of
approximately 30 to 60 seconds is necessary before logging in
following the reset.
2005-09-13
CN-5000 User Manual
26