ATEN CN-5000 - Manual (Page 17)

Chapter 2.
Hardware Setup
Front View
No. Component Description
1. Reset / Firmware
Upgrade Switch Pressing and holding this switch in while powering ON the
CN-5000 returns it to the factory default firmware level.
After the CN-5000 has been powered ON, pressing and
holding this switch in for more that two seconds performs
a system reset.
Note: This switch is recessed and must be pushed with a
thin object - such as the end of a paper clip, or a ballpoint
pen.
2. Data Speed LED The LED lights GREEN to indicate 10 Mbps data
transmission speed.
The LED lights ORANGE to indicate 100 Mbps data
transmission speed.
3. Link LED Flashes GREEN to indicate that a Client program is
accessing the device.
4. Power LED Lights ORANGE when the CN-5000 is powered up and
ready to operate.
1
2
3
4
2005-09-13
5