Agilent Technologies N8201A - Manual (Page 105)

Preventive Maintenance 5
Agilent N8201A Performance Downconverter Synthetic Instrument Module, 3 Hz to 26.5 GHz 101
Half-Rack-Width Instrument
Bench Top Instrument
To install the instrument in a rack
Step Note
1 Make sure the system is powered off.
2 Insert the attached instruments in the same
slot from which you removed them, sliding
them along the support rails until they meet
the rack-mount ears.
• The rack-mount ears stop the instruments at
the correct depth.
3 Replace the rack panel in front of the
instruments and secure the four corner
screws.
• The screws are located near the corners of
the face of the instrument.
• Use a #2 Phillips screwdriver.
4 Confirm that the instrument is turned off.
5 Connect the appropriate cables to the
instruments (front and rear), including the
power cords.
6 Power on the system. .
To install an instrument in a bench top system
1 Make sure the system is powered off.
2 Connect all cables to the instrument (front
and rear), including the power cord.
3 Connect the power cord to the AC power
source.
4 Power on the system.
5 Set the instrument GPIB address, if
necessary.