Agilent Technologies N8201A - Manual (Page 34)

30 Agilent N8201A Performance Downconverter Synthetic Instrument Module, 3 Hz to 26.5 GHz
2 Hardware Setup and Configuration
1 Connect a LAN cable from the LAN connector on your PC to an empty connector on your
internal local area network or LAN hub.
2 Connect a LAN cable from the LAN connector on the rear panel of the
N8201A performance downconverter to an empty connector on your internal local area
network or LAN hub.
3 Turn on power to the PC.
4 Turn on power to the N8201A performance downconverter and wait until the LAN LED
turns solid green or until you hear an attenuator click from within the
N8201A performance downconverter; this can take up to four minutes depending on
whether the instrument is using DHCP or Auto IP.