Agilent Technologies N8201A - Manual (Page 109)

Service, Support, and Safety Information 6
Agilent N8201A Performance Downconverter Synthetic Instrument Module, 3 Hz to 26.5 GHz 105
All light-emitting diodes (LEDs) used in this product are Class 1 LEDs per IEC 60825-1.
Equipment Installation
Install the instrument or system so that the detachable power cord is readily identifiable
and is easily reached by the operator. The detachable power cord is the disconnecting
device. It disconnects the mains circuits from the mains supply before other parts of the
instrument or system. The instrument front panel switch is only a standby switch and is not
a LINE switch. Alternatively, an externally installed switch or circuit breaker (which is
readily identifiable and is easily reached by the operator) may be used as a disconnecting
device.
Acoustic Noise Emission/Geraeuschemissio n
LpA <70 dB
Operator position
Normal position
per ISO 7779 LpA <70 dB
am Arbeitsplatz
normaler Betrieb
nach DIN 45635 t.19
WA R N I N G
This is a Safety Class 1 Product (provided with a protective earthing ground
incorporated in the power cord). The mains plug shall be inserted only in a socket
outlet provided with a protective earth contact. Any interruption of the protective
conductor inside or outside of the product is likely to make the product
dangerous. Intentional interruption is prohibited (IEC 348 clauses 17.3.3 c and
17.3.4).
WA R N I N G
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE.
Do not operate the instrument or system in the presence of flammable gases or
flames.
WA R N I N G
Danger of explosion if battery is incorrectly replaced. Replace only with the same
or equivalent type recommended. Discard used batteries according to
manufacturer’s instructions.