Method 3: using usb port – Vaisala viewLinc 4.3 User Manual
Page 21
Connecting Devices
viewLinc 4.3
4
|
4
13
Step 1: Discover the Digi Device
1
Obtain a reserved (recommended) or static IP address for your Digi
Device from your IT department. If your networking policy requires
you to reserve IP addresses using DHCP, see http://www.vais-
ala.com/en/lifescience for instructions.
2
Insert the Digi driver CD into viewLinc Server.
3
The Digi Device Setup Wizard launches automatically. Click Next.
4
Select the Device that matches the MAC address from the bottom of
your Digi Device. Click Next.
If your Device is on a different subnet from the server, you will
need to know the IP address of the Digi Device and launch the
RealPort installer on the Digi Driver CD.
Step 2: Configure RealPort and Install Drivers
1
In the Configure Network Settings screen, enter an IP address
(provided by your IT department). Click Next two times.
2
In the Configure RealPort Settings screen, select Install Digi
RealPort on this computer
. Click Next.
3
Click Next again. The settings are saved.
4
Click Finish.
Repeat Step 1 and Step 2 for each Digi Device.
Method 3: Using USB Port
You can connect Vaisala Veriteq Devices directly to PCs using a USB Port: