Anritsu MG3641A User Manual
Page 140
SECTION 6 GPIB
6-34
:AMPLitude[ :OUT]:RELative <Boolean>
Function
Turns ON or OFF the relative level display mode.
Parameter
<Boolean> = ON or 1
OFF or 0
Unit
<Non term>
Restriction
None
:AMPLitude[ :OUT]:RELative?
Function
Reads out the state of relative level display mode.
Response
Relative level display mode = OFF
ON
Restriction
None
:AMPLitude[ :OUT]:OFFSet <Numeric> <Ampl term>
Function
Sets the output level offset value.
Parameter
<Numeric> = –55 dB to 55 dB
Unit
<Ampl term>
Restriction
Unit is dB, only.
:AMPLitude[ :OUT]:OFFSet?
Function
Reads out the output level offset value.
Response
Level offset value
Restriction
None
:AMPLitude[ :OUT]:ISOLation <Boolean>
Function
Turnd ON or OFF the isolation mode.
Parameter
<Boolean> = ON or 1
OFF or 0
Unit
<Non term>
Restriction
None
:AMPLitude[ :OUT]:ISOLation?
Function
Read out the state of isolation mode.
Response
Isolation mode = OFF
ON
Restriction
None
:AMPLitude[ :OUT]:SWEep <Character>
Function
Executes output level sweep.
Parameter
<Character> = RUN
STOP
PAUSE
CONT
Unit
<Non term>
Restriction
None
:AMPLitude[ :OUT]:SWEep:STARt <Numeric> <Ampl term>
Function
Sets the start level for a sweep.
Parameter
<Numeric> = –143 dBm to +23 dBm
Unit
<Ampl term>
Retriction
None