Anritsu MG3641A - Manual (Page 42)

SECTION 4 OPERATING INSTRUCTIONS
In case the AC line voltage fed to the unit is not an appropriate one, the interior of the signal generator may be
damaged because of abnormal voltages. Before switching on the MG3641A/MG3642A, check to make sure
that the AC line voltage meets the specified value.
In normal operation of this signal generator, leave the " " switch of the rear panel permanently set in the " "
position, with the accessory power cord plugged into the AC inlet and the current outlet, and control the on/off
operations of the signal generator only by the "Stby/On" switch located on the front panel.
Table 4-1. Indications of Power Indicator Lamps and Power Statuses
Status of power switch Status of power indicator lamp
" " swich "Stby/On" switch "Stby" (Green) "On" (Orange)
Stby Unlit Unlit
Stby Lit Unlit
On Unlit Lit
WARNING