Anritsu MG3641A - Manual (Page 35)

SECTION 2 PRECAUTION
2-5
2.4.1 Connecting the Power Cord
Check that the "
●
| " switch on the rear panel is turned off (switched to the (O) side).
Insert the power plug into an outlet, and connect the other end to the power inlet on the rear panel. To ensure that the
instrument is grounded, always use the supplied 3-pin power cord, and insert the plug into an outlet with a ground
terminal.
WARNING
If the power cord is connected without the instrument grounded, there is a risk of receiving a fatal electric
shock. In addition, the peripheral devices connected to the instrument may be damaged.
When connecting to the power supply, DO NOT connect to an outlet without a ground terminal. Also, avoid
using electrical equipment such as an extension cord or a transformer.
CAUTION
If an emergency arises causing the instrument to fail or malfunction, disconnect the instrument from the power
supply by either turning off the "
●
| " switch on the rear panel (switch to the (O) side), or by pulling out the
power cord or the power inlet.
When installing the instrument, place the instrument so that an operator may easily operate the "
●
| " switch.
If the instrument is mounted in a rack, a power switch for the rack or a circuit breaker may be used for power
disconnection.
It should be noted that, the "Stby/On" switch on the front panel of the instrument is a standby switch, and
cannot be used to cut the main power.