Anritsu MG3641A - Manual (Page 151)

SECTION 6 GPIB
6-45
6.7.7 MEMORY subsystem
:MEMory:RECall <Numeric> or <Character>
Function Recall from the memory.
Parameter <Numeric> = 0 to 999
<Character> = UP
DOWN
Unit <Non term>
Restriction None
:MEMory:RECall:TYPE <Numeric>
Function Selects the recall type of the memory.
Parameter <Numeric> = 0 (ALL)
1 (FREQ)
2 (FREQ&LEVEL)
Unit <Non term>
Restriction None
:MEMory:STORe <Numeric>
Function Store to the memory.
Parameter <Numeric> = 0 to 19
Unit <Non term>
Restriction None
:MEMory:SKIP <Numeric>
Function Sets the skip of memory block.
Parameter <Numeric> = 0 to 19
Unit <Non term>
Restriction None
:MEMory:CLEar <Numeric>, <Numeric>
Function Clear the memory.
Parameter <Numeric> = 0 to 999
Unit <Non term>
Restriction None
:MEMory:SWEep <Character>
Function Executes the memory sweep.
Parameter <Character> = RUN
STOP
PAUSE
CONT
Unit <Non term>
Restriction None
:MEMory:SWEep:STARt <Numeric>
Function Sets the start address for a sweep.
Parameter <Numeric> = 0 to 999
Unit <Non term>
Restriction None