Campbell Scientific CR5000 Measurement and Control Module - Manual (Page 10)

CR5000 Overview
OV-6
OV2.3 Data Tables
The CR5000 can store individual measurements or it may use its extensive
processing capabilities to calculate averages, maxima, minima, histogams,
FFTs, etc., on periodic or conditional intervals. Data are stored in tables such
as listed in Table OV2-1. The values to output are selected when running the
program generator or when writing a datalogger program directly.
Table OV2-1. Typical Data Table
TOA4 StnName Temp
TIMESTAMP RECORD RefTemp_Avg TC_Avg(1) TC_Avg(2) TC_Avg(3) TC_Avg(4) TC_Avg(5) TC_Avg(6)
TS RN degC degC degC degC degC degC degC
Avg Avg Avg Avg Avg Avg Avg
1995-02-16 15:15:04.61 278822 31.08 24.23 25.12 26.8 24.14 24.47 23.76
1995-02-16 15:15:04.62 278823 31.07 24.23 25.13 26.82 24.15 24.45 23.8
1995-02-16 15:15:04.63 278824 31.07 24.2 25.09 26.8 24.11 24.45 23.75
1995-02-16 15:15:04.64 278825 31.07 24.21 25.1 26.77 24.13 24.39 23.76
OV3. PC9000 Application Software
PC9000 is a Windows ™ application for use with the CR5000. The software
supports CR5000 program generation, real-time display of datalogger
measurements, graphing, and retrieval of data files.
OV3.1 Hardware and Software Requirements
The following computer resources are necessary:
• IBM PC, Portable or Desktop
• 8 Meg of Ram
• VGA Monitor
• Windows 95 or newer
• 30 Meg of Hard Drive Space for software
• 40 Meg of Hard Drive Space for data
• RS232 Serial Port
The following computer resources are recommended:
• 16 Meg of Ram
• 33 MHz 486 or faster
• Mouse
OV3.2 PC9000 Installation
To install the PC9000 Software:
• Start Microsoft Windows
• Insert diskette 1 (marked 1 of 2) in a disk drive.
• From the Program Manager, select File menu and choose Run
• Type (disk drive):\setup and press Enter e.g. a:\setup<Enter>
• The setup routine will prompt for disk 2.