AMX Modero CV7 - Manual (Page 119)

Firmware Pages and Descriptions
107 7" Modero Touch Panels
Calibration Page
This page (FIG. 98) allows you to calibrate the touch panel using a pre-selected touch driver.
 Press and hold the grey Front Setup Access button (below the Modero LCD) for 6 seconds to
access the Calibration page.
 Press the crosshairs to calibrate the panel and return to the last active firmware page.
Wireless Settings Page
The Wireless Settings page (FIG. 100) sets the communication parameters for the installed wireless CF
card (either 802.11b/g). This information includes its corresponding IP communication parameters,
wireless communication settings, and read the device number assigned to the Modero panel. Both panels
can use 802.11b/g for wireless communication.
Once the panel has been updated with the latest Modero firmware, some encryption and security features
may/may not be supported depending on the type of wireless card being used.
FIG. 98 Calibration page (actually 3 separate screens)
The request to touch the crosshairs
is the first on-screen message
Calibration successful is the second
on-screen message that appears
On-screen crosshairs used for
calibration of the touch device
after the calibration process is
completed
If the calibration was improperly set and you cannot return to the Calibration
page (through the panel’s firmware); you can access this firmware page via
G4 WebControl where you can navigate to the Protected Setup page and press the
Calibrate button through your VNC window.
This action causes the panel to go to the Calibration page seen above, where you
can physically recalibrate the actual touch panel again using the above procedures.
FIG. 99 Wireless Settings page (showing how each card supports its own security features)
802.11b wireless card 802.11g wireless card