AMX Modero CV7 - Manual (Page 52)

Installation
40 7" Modero Touch Panels
13. Reconnect the terminal power connector on the 12 VDC-compliant power supply and apply power.
Installing the NXD into a Flat Surface using #4 screws
Mounting screws (#4-40, included) are secured through two sets of circular holes located at the left and
right sides of the NXD-CV7. The most important thing to remember when mounting the NXD Wall
Mount is that the outer frame (Mounting Tabs) must be installed flush against the mounting
surface.
 Refer to SP-2258-01 for detailed installation dimensions (reproduced in FIG. 40).
 It is recommended that you cutout the surface slightly smaller than what is outlined in the
installation drawings so that you can make any necessary cutout adjustments.
1. Prepare the area by removing any screws or nails from the surface before beginning the cutout
process.
2. Cut out the surface for the NXD Wall Mount unit using the dimensions shown in FIG. 40.
3. Remove the Faceplate/bezel (A in FIG. 41) from the main NXD unit (B in FIG. 41) by gripping the
faceplate and pulling with gentle outward force.
4. Thread the incoming power, RJ-45, Ethernet, USB, and any optional audio/video wiring (from their
terminal sources) through the surface opening. Leave enough slack in the wiring to accommodate
any re-positioning of the panel.
5. Connect all data and power wiring connectors to their corresponding locations along the left side of
the (un-powered) NXD touch panel.
FIG. 40 NXD-CV7 Wall Mount panel dimensions using #4-40 mounting screws