AMX Modero CV7 - Manual (Page 46)

Installation
34 7" Modero Touch Panels
8. Gently insert the Button Trim Ring latches into their corresponding openings on the outer surface of
the internal Faceplate (FIG. 35).
9. Firmly press down around the Button Trim Ring until all of the latches are securely inserted into
their openings on the Faceplate, and the Button Trim Ring is securely fastened. Verify the Button
Trim Ring is firmly inserted onto the Faceplate and that there are no gaps between this Trim Ring
and the outer surface of the Faceplate.
10. Place the Faceplate back onto the main NXD-CV7 unit. Make sure to align the Microphone, Light,
and PIR Motion sensor locations on the main unit to their respective openings on the Faceplate
assembly.
Pre-Wall Installation of the Rough-In Box
Wall Mount panels (NXDs) are contained within an outer housing (back box). This back box is not
removed when installing the NXD into a Rough-In Box (CB-TP7). The back box is only removed to gain
access for the replacement of the internal components.
The CB-TP7 is an optional metallic box that is secured onto a stud/beam in a pre-wall setting (where no
walls are present). Installation procedures and configurations can vary depending on the installation
environment. This section describes the installation procedures for the most common installation
scenario. The most important thing to remember when mounting this rough-in box is that the NXD-CV7
Mounting Tabs must lie flush against the outside of the sheetrock (FIG. 36).
 Refer to SP-2258-02 for detailed installation dimensions.
 It is recommended that you cut out the surface slightly smaller than what is outlined in the
installation drawings so that you can make any necessary cutout adjustments.
 The wiring knockouts on the left side will be used for the NXD-CV7 Wall Mount panel
connectors, so always secure the rough-in box to the stud using the Stud Mounting Holes on
the right side of the box.
FIG. 35 Inserting the Button Trim RIng
Button openings
Button Trim Ring
Faceplate (outer surface shown)
INSTALLER: LEAVE A GAP BETWEEN THE STUD AND ROUGH-IN BOX
MOUNTING TABS TO ACCOMMODATE THE DRYWALL or SHEETROCK.
This gap allows the installation of the drywall or sheetrock after the CB-TP7 Rough-In
Box has been installed.