AMX Modero CV7 - Manual (Page 19)

CV7 Touch Panel Accessories
7 7" Modero Touch Panels
CV7 Touch Panel Accessories
Overview
The following section outlines and describes both the included accessories and other AMX equipment
available for these touch panels.
NXA-AVB/ETHERNET Breakout Box (FG2254-10)
The NXA-AVB/ETHERNET Breakout Box (FIG. 4) is included as part of the CV7 Kit configuration (panel
and box) but can be purchased as a separate accessory. This box facilitates the installation and distribution of
video, data, and audio to Modero touch panels located up to 200 feet (60.96 m) from the AVB box. This unit
accepts either Composite or S-Video from standard video devices.
This breakout box can be mounted on either a horizontal flat surface or within an equipment rack (by using an
optional AC-RK Rack Kit).
Product Specifications
FIG. 4 NXA-AVB/ETHERNET Breakout Box (front and rear views)
NXA-AVB/ETHERNET Specifications
Dimensions (HWD): • 1.50" x 5.55" x 4.88" (3.81 cm x 14.10 cm x 12.40 cm)
• Width when attached to mounting ears: 6.65" (16.89 cm)
Power Consumption: • 50mA (with audio/video input)
• 23mA (with no audio/video)
• Routed through NXA-AVB/Ethernet using a 12 VDC-compliant power supply
Certifications: • FCC Part 15 Class B, CE, and EN60950
Features: • Accepts either Composite or S-Video (video-capable panels only)
• Provides audio distribution to the non-video touch panels over a CAT5 cable (up to
200 ft.)
• Provides video/audio distribution to the video-capable touch panels over CAT5
cable up to 200 ft.(60.9 m)
Availability: • This unit is included with CV5, CV7, CV10, and 1200V-Series Kit configurations
Front Components: • 2-pin 3.5 mm Phoenix connector for power to the touch panel
• Green LED provides an indication of power status
• RJ-45 connector provides Ethernet signals to the touch panel
• RJ-45 connector provides differential audio and video signals to the touch panel
(panel type dependant)
Rear Components: • 6-pin 3.5 mm Phoenix connector for in-bound (left/right channel) audio
• 4-pin 3.5 mm Phoenix connector for out-bound (from microphone) audio
• BNC connector (female) for Composite or Chroma ( video-capable panels only)
• BNC connector (female) for luminance (video-capable panels only)
• RJ-45 connector for Ethernet input from the control system
• 2-pin 3.5 mm Phoenix connector for in-bound power
Power In
(front)
Ethernet (to panel)
Audio/Video
Power (to panel)
S-Video Chroma Composite/
Mic Out
Audio
In
Ethernet In
S-Video
Luma
(rear)
(to panel)