AMX Modero CV7 - Manual (Page 31)

CV7 Touch Panel Accessories
19 7" Modero Touch Panels
3. While holding the outer housing and base plate at an angle (to prevent it from sliding), use a grounded
Phillips-head screwdriver to remove the four Housing Screws.
4. Rotate the panel back over (while gripping the entire unit and outer housing) and rest the base back onto a
flat surface.
5. Gently tilt the LCD panel backwards to expose the Tilt Bracket/Speaker assembly (FIG. 19).
6. Locate the two screw holes at either sides of the front speaker grill and then use a grounded
Phillips-head screwdriver to remove the two Tilt Bracket Screws (FIG. 17). This procedure both loosens
the rear Tilt Bracket cover plate (with the AMX logo and Hinge brackets) and provides greater flexibility
for the removal of the outer housing. Without this step, the Hinge brackets (FIG. 17) present an obstacle
to the removal of the outer housing and restrict access to the circuit board.
7. Tilt the LCD panel back up to gain better access to the Tilt Bracket cover plate.
8. In a single motion, carefully pull both the Tilt Bracket cover plate and outer housing up and then out
(away from the LCD panel) to expose the internal circuit board (FIG. 18).
Note the location of the four plastic adhesive "feet". Once the outer housing is placed
back onto the panel, these "feet" must be placed back onto their original locations so
they can fit into their provided openings on a Battery Base.
FIG. 17 Location of the Tilt Bracket screws
FIG. 18 Removal of the outer housing and wireless card location
Base
Outer Housing
Hinge Brackets (2)
Tilt Bracket Screws (2)
These two screws must
first be removed before
being able to remove
the outer housing.
Tilt Bracket/Speaker assembly
Outer housing
Tilt Bracket cover plate
Base
Outer Housing
installation holes
(located on front panel)
(must be removed first)