ATEN Altuscn Matrix KVM Switch KM0532 - Manual (Page 114)

KM0032 / KM0532 / KM0932 User Manual
102
8. Click Upgrade to start the upgrade procedure. As the upgrade proceeds,
progress information is shown on the screen. Once the upgrade completes
successfully, the switch resets itself.
9. Log in again, and check the firmware version to be sure it is the new one.
Firmware Upgrade Recovery
Should the switch’s firmware upgrade procedure fail, and the switch becomes
unusable, the following firmware upgrade recovery procedure will resolve the
problem:
1. Power off the switch.
2. Press and hold the Reset Switch in (see Reset Switch, page 7 for details).
3. While holding the Reset Switch in, power the switch back on.
This causes the switch to use the original factory installed main firmware
version. Once the switch is operational, you can try upgrading the main
firmware again.
Adapter Cable Firmware Upgrade Recovery
Should the adapter firmware upgrade procedure fail for one of the KVM
Adapter Cables and the adapter becomes unusable, the following adapter
firmware upgrade recovery procedure will resolve the problem:
1. Unplug the Adapter from the computer it is connected to.
2. Slide its Firmware Upgrade Recovery Switch (located next to the Cat 5e
connector) to the RECOVER position.
3. Plug the Adapter back into the computer.
4. Repeat the Adapter upgrade procedure.
5. After the Adapter has been successfully upgraded, unplug the Adapter
from the computer it is connected to; slide the Firmware Upgrade
Recovery Switch back to the NORMAL position; and plug the Adapter
back in.