Km0032 front view – ATEN Altuscn Matrix KVM Switch KM0532 User Manual
Page 20
KM0032 / KM0532 / KM0932 User Manual
8
KM0032 Front View
No.
Component
Description
1
Power LED
Lights (blue) to indicate that the unit is receiving power.
2
Port LEDs
The Port LEDs provide status information about their
corresponding KVM Ports, They light as follows:
GREEN: The computer connected to its corresponding
port is On Line.
GREEN & Flashing: Its corresponding port is connected to
a cascaded KVM switch.
RED: The computer attached to its corresponding port is
Selected (it has the KVM focus).
The LED does not light when there is no online device
connected to its corresponding port.
3
Station ID LED
The KM0032's Station ID is displayed here. It indicates the
KM0032's position in a daisy chained installation. The first
station in the chain has a Station ID of 01; the second has a
Station ID of 02, etc.
4
Reset Switch
Pressing in this button performs a system reset. When the
system is reset, the switch beeps, and then the KVM port
LEDs flash in succession until the reset is completed. After
the reset is completed you can login again.
Note: This switch is recessed and must be pushed with a
thin object.
5
Cover Latch
6
Firmware
Upgrade
Recovery Switch
During normal operation and while performing a firmware
upgrade, this switch should be in the NORMAL position. If a
firmware upgrade operation does not complete successfully,
this switch is used to perform a firmware upgrade recovery
(see Firmware Upgrade Recovery, page 102, for details).
1
3
6
5
4
2