Avaya S8710 - Manual (Page 15)

1 Introduction
Installing and Configuring the Avaya S8700 or S8710 Media Server 15
June 2004
1
Introduction
These procedures are for installing Avaya Communication Manager and configuring a new Avaya S8700
or S8710 Media Server and associated components in either a Multi-Connect or an IP-Connect
configuration. The installation procedures for both models are basically the same; where they differ is
noted.
As part of the procedures for configuring the various pieces of hardware, you use two administration
interfaces: the Maintenance Web Interface and a command line interface using either telnet or a terminal
emulation program such as Avaya Native Configuration Manager. You also use the Avaya Installation
Wizard to configure the media servers.
There are no requirements to install the media servers before the media gateways; however, the license
file only allows 30 minutes to "see" the administered and connected IP Server Interface circuit packs.
The following information is included in this installation procedure:
• Pre-installation information on page 16
— Equipment specifications on page 18
— Required hardware on page 20
• Connecting to the customer’s network on page 22
• Connecting the USB modems on page 24
• High level overview of installation process on page 25
• Configuring the hardware in the rack on page 27
— Configuring the SNMP modules in the UPS on page 28
— Configuring the SNMP subagent in the Avaya Ethernet switch (if used) on page 31
— Configuring the media server on page 33
— Configuring second media server on page 41
• Translating the IPSIs on page 43
• Connecting to the IPSIs on page 49
• Completing the installation administration on page 57
• Installing the media gateways on page 67
• Testing the media server installation on page 69
• Accessing the media server on page 81
• Troubleshooting an installation on page 89