Avaya S8710 User Manual
Page 52
4 Connecting to the IPSIs
Programming the IPSI circuit packs
52
Installing and Configuring the Avaya S8700 or S8710 Media Server
June 2004
Figure 1: Connecting directly to the IPSI
NOTE:
Make sure you have the password before proceeding.
1
Connect the services laptop computer to the top port on the IPSI circuit pack faceplate.
2
From the services laptop Start Menu, click Start > Run to open the Run dialog box.
3
Type
command
and press Enter
to open a MS-DOS Command Line window.
4
Type
arp -d 192.11.13.6
and press
Enter
to clear the ARP cache in the laptop. This command
responds with one of the following:
•
The command line prompt when the cache has been cleared.
•
The phrase: The specified entry was not found. This is returned when the specified IP
address does not currently contain an entry in the ARP cache.
5
Type
telnet 192.11.13.6
and press Enter to open the Telnet window and connect to the IPSI
Prompt = [IPSI]:
NOTE:
While connected to the IPSI, type
help
or
?
to obtain online help. Most commands have
two or three letter abbreviations.
Figure notes
1
Services laptop
2
PCMCIA Network Interface Card (NIC)
3
NIC adapter cable (if necessary)
4
CAT5 crossover cable to IPSI
cadlipsi KLC 031502
1
2
CLK
S
E
R
V
I
C
E
N
E
T
W
O
R
K
3
4