Avaya S8710 - Manual (Page 45)

3 Translating the IPSIs
Administering the IPSIs
Installing and Configuring the Avaya S8700 or S8710 Media Server 45
June 2004
Administering the IPSIs
NOTE:
This procedure enables the IPSI circuit packs and allows them to control the port
networks.
1 Type change system-parameters ipserver-interface and press Enter.
2 Verify that the Primary and Secondary Subnet Addresses are correct.
The subnet addresses must match the most significant 3 octets (the first three groups of digits in
the subnet address) of the Server IP address.
An asterisk (*) to the right of the Subnet Address field means that although a subnet address is
displayed, it is not the correct one; Avaya Communication Manager does not have the subnet
information. After verifying the displayed information, submit this form with or without changes
to update the software with the correct subnet information.
CAUTION:
If the information displayed in the Primary Control Subnet Address and/or Secondary
Control Subnet Address fields is not correct, it must be changed on the media servers.
Use the Maintenance Web Interface; under Server Configuration and Upgrades, click
Configure Server to change the media server configuration. Then return here to perform
this step.
3 Set the Switch Identifier: field to the switch ID letter (A thru J; A is the default setting).
4 Set the IPSI Control of Port Networks: field to enabled.
5 Press Enter to effect the change.
Adding IPSI information
NOTE:
The information you provide differs, depending on whether the IPSIs get static addresses
or they are assigned automatically through DHCP.
change system-parameters ipserver-interface Page 1 of 1
IP SERVER INTERFACE (IPSI) SYSTEM PARAMETERS
SERVER INFORMATION
IPSI Host Name Prefix: vodka
Primary Control Subnet Address: 198.152.254. 0 *
Secondary Control Subnet Address: 198.152.255. 0 *
OPTIONS
Switch Identifier: A
IPSI Control of Port Networks: enabled