Avaya S8710 User Manual
Page 53
4
Connecting to the IPSIs
Programming the IPSI circuit packs
Installing and Configuring the Avaya S8700 or S8710 Media Server
53
June 2004
6
Type
ipsilogin
and press Enter (abbreviated command = il).
NOTE:
The craft login used on the IPSI has a different password than the craft login used on the
media servers.
7
Log in as craft.
Prompt = [IPADMIN]:
Type show control interface and press Enter.
8
Type
show port 1
and press Enter to see the current
settings.
9
Type
set control interface
ipaddr netmask
and press Enter, where
ipaddr
is the customer-
provided IP address and
netmask
is the customer provided subnet mask.
10
Press Enter to effect the changes.
11
Type
show control interface
and press Enter.
The IP address, subnet mask, and default gateway information will be displayed.
Verify that the proper information was entered.
12
If required, type
set control gateway
gateway
and press Enter, where
gateway
is the customer-
provided IP address for their gateway.
13
Press Enter to effect the changes.
14
If required, use the
set vlan priority
,
set vlan tag
,
set vlan id
,
set port negotiation
(1=disable),
set port
duplex
(1 full),
set port speed
(1 100 MB), and
set diffserv
commands to enter VLAN
and diffserv parameters for the IPSI. Use Help to obtain syntax guidelines for these commands.
15
Type
reset
and press Enter
Answer Y to the warning.
NOTE:
Resetting the IPSI terminates the administration session. If further administration is
required, start a new telnet session to the IPSI.