Sony DCR-PC105 - Manual (Page 208)

208
Symptom Cause and/or Corrective Actions
• VIDEOINPUT is not set correctly in the menu settings.
c Set it correctly (p. 194).
• Moisture condensation has occurred.
c Remove the cassette and leave your camcorder for at
least 1 hour to acclimatize (p. 221).
• Some troubles have occurred in your camcorder.
c Remove the cassette and insert it again, then operate
your camcorder.
c Disconnect the AC Adaptor from a wall outlet or
remove the battery pack, then reconnect the AC Adaptor
or the battery pack in about 1 minute. Turn the power
on. If the functions still do not work, press the RESET
button using a sharp-pointed object. (If you press the
RESET, all the settings including the date and time
return to the default.) (p. 15, 16, 230)
• This is because some functions use a linear mechanism.
This is not a malfunction.
• Charging has completed.
• The battery pack is not properly installed.
c Install it properly (p. 15).
• The POWER switch is not set to OFF (CHG).
c Set it to OFF (CHG) (p. 16).
• The battery pack is not properly installed.
c Install it properly (p. 15).
• Something is wrong with the battery pack.
c If the problem persists, unplug the AC Adaptor
immediately and contact your Sony dealer or local
authorized Sony service facility.
• DISPLAY/BATT INFO is pressed.
c Press the LCD screen lightly.
c Press DISPLAY/BATT INFO on your camcorder or
DISPLAY on the Remote Commander (p. 25, 43).
c Adjust the screen (CALIBRATION) (p. 224).
• The USB cable was connected before installation of the
USB driver was complete.
c Uninstall the incorrect USB driver and reinstall the
USB driver (p. 164, 170).
• USB STREAM is set to OFF in the menu settings.
c Set it to ON (p. 199).
• Moisture has started to condense in your camcorder
(p. 221).
c Remove the battery pack, then install it again (p. 15).
You cannot dub with the A/V
connecting cable.
The melody or beep sounds for
5 seconds.
No function works though the power
is on.
When you set the POWER switch to
VCR or OFF (CHG), if you move
your camcorder, you may hear a
clattering sound from inside your
camcorder.
While charging the battery pack, the
CHARGE lamp does not light up.
You cannot charge the battery pack.
While charging the battery pack, the
CHARGE lamp flashes.
The buttons do not appear on the
touch panel.
The buttons on the LCD screen do
not work.
Image data cannot be transferred to
your computer by the USB
connection.
The cassette cannot be ejected even if
the cassette lid is open.
The cassette cannot be ejected.
Types of trouble and how to correct trouble