Armstrong World Industries HWC PREMIER 183 - Manual (Page 55)

3-6
UNIT TEAR DOWN Magic-Pak: HW/HWC
SRM-HW/HWC 8/99
R
O
T
A
T
IO
N
MOUNTING SCREWS
EVAPORATOR BLOWER
ASSEMBLY
CONTROL PANEL
SCREWS
CHASSIS BASE
PERMAGUM SEAL
(BETWEEN BASE RAIL AND CHASSIS BASE)
Figure 3-5
Evaporator Blower Assembly Removal:
The evaporator blower assembly is removable as one complete section.
To remove the assembly, the chassis must be removed first (see page 3-
4). Refer to the following directions and Figure 3-5.
To remove the evaporator blower assembly:
1. Remove the four mounting screws from the blower assembly.
2. Remove the four control panel screws.
3. Slide control panel toward yourself about 1".
4. Disconnect the electrical wiring to the motor.
5. Pull blower assembly up and out from chassis.