Beijer Electronics BFI-H2 V1.12 - Manual (Page 15)

User Guide Revision 1.12
15
3.10. Guidelines for mounting IP40 Units
 Before mounting the drive, ensure that the chosen location meets the environmental condition requirements for the drive shown in
section 13.1
 The drive must be floor standing, placed on a Horizontal and suitably flat surface

The Enclosure must be anchored to an adjacent wall using the mounting points provided

All Enclosure vents must remain clear with airflow unobstructed

The mounting site and chosen mountings should be sufficient to support the weight of the drives
Note :
Typical drive heat losses are 3% of operating load
conditions.
Above are guidelines only and the operating ambient
temperature of the drive MUST be maintained at all
times.
Level Ground