Beijer Electronics BFI-H2 V1.12 - Manual (Page 22)

User Guide Revision 1.12
22
4.5. Motor Terminal Box Connections
Most general purpose motors are wound for operation on dual voltage supplies. This is indicated on the nameplate of the motor
This operational voltage is normally selected when installing the motor by selecting either STAR or DELTA connection. STAR always gives the
higher of the two voltage ratings.
Incoming Supply Voltage Motor Nameplate Voltages Connection
230 230 / 400
Delta
400 400 / 690
400 230 / 400 Star
4.6. Motor Thermistor Connection
Where a motor thermistor is to be used, it should be connected as follows :-
Additional Information

Compatible Thermistor : PTC Type, 2.5kΩ trip level
 Use a setting of P1-13 that have Input 5 function as External Trip, e.g. P1-
13 = 6. Refer to section Error! Reference source not found. for further
etails.