Beijer Electronics BFI-H2 V1.12 - Manual (Page 62)

User Guide Revision 1.12
62
P0-57 Ud / Uq - - - -
Internal Value, Contact your local Drive Distributor
P0-58 Load Torque Profile Current Values - - - A
Parameter contains the 5 Current values measured during the Load Torque Characteristic Auto-Tune function.
Five entry display: First display –
Current at minimum speed
Second display – Current at first measurement interval
Third display – Current at second measurement interval
Fourth display – Current at third measurement interval
Fifth display – Current at maximum speed
P0-59 Frequency input speed - - - -
Displays the speed reference from the Frequency input channel
P0-60 Calculated slip speed - - - -
Displays the calculated slip speed in Hz or rpm
P0-61 Relay Control Speed Hysteresis - - - -
Relay control speed hysteresis
P0-63 Post ramp speed reference - - - -
Displays the post ramp speed reference in Hz or rpm
P0-64 Switching frequency - - - -
Displays the actual effective Switching frequency. This may be less than the value set in P2-24 if reduced by the thermal fold-back
function (enabled in P6-02)
P0-65 Drive life time - - - -
Displays the time for which the drive has been powered up in Hours, Minutes and Seconds since date of manufacture
P0-68 User ramp value - - - -
Displays the User ramp value received from the Fieldbus interface. This ramp function is only active when P5-07 = 1 (Enabled)
P0-69 I2C error counter, - - - -
Internal Value, Contact your local Drive Distributor
P0-70 Option Module identification code - - - -
Identifies Type of Option Module connected to drive option module slot
P0-71 Fieldbus module ID - - - -
Fieldbus module Identification Code
P0-72 Ambient temperature - - - -
Displays the drive internal ambient temperature
P0-73 24 Hour Timer Value - - - -
Displays the value of the internal 24hour counter, displayed in Hours and Minutes. This value can be set using the drive keypad (UP
and DOWN keys when drive stopped) and will be reset to zero on power up.
P0-74 L1 input voltage - - - -
Displays the L1 line input voltage
P0-75 L2 input voltage - - - -
Displays the L2 line input voltage
P0-76 L3 input voltage - - - -
Displays the L3 line input voltage
P0-77 Test parameter 1/2 - - - -
Internal Value, Contact your local Drive Distributor
P0-78 Test parameter 3/4 - - - -
Internal Value, Contact your local Drive Distributor
P0-79 Control/boot-loader version - - - -
Displays the boot-loader version and motor control library version
P0-80 Specified internal parameter - - - -
Displays the value selected by P6-28. Usually used in conjunction with the PLC function.