Beijer Electronics BFI-H2 V1.12 - Manual (Page 25)

User Guide Revision 1.12
25
5.3. Advanced Keypad Operation Short Cuts – Standard LED Keypad (IP20 Drives)
Function When Display shows... Press... Result Example
Fast Selection of
Parameter Groups
Note : Parameter Group
Access must be enabled
P1-14 = 101

xxx
+
The next highest
Parameter group is
selected
Display shows


Press
+
Display shows


xxx
+
The next lowest
Parameter group is
selected
Display shows

Press
+
Display shows

Select lowest Group
Parameter

xxx
+ The first parameter of a
group is selected
Display shows


Press
+
Display shows

Set Parameter to
minimum value
Any numerical value
(Whilst editing a
parameter value)
+ The parameter is set to
the minimum value
When editing P1-01
Display shows
.

Press
+
Display shows
.
Adjusting individual digits
within a parameter value
Any numerical value
(Whilst editing a
parameter value)
+ Individual parameter
digits can be adjusted
When editing P1-10
Display shows
 
Press
+
Display shows

Press
Display shows

Press
+
Display shows

Press
Display shows

Etc...
5.4. Drive Operating Displays – Standard LED Keypad (IP20 Drives)
Display Status
 Drive mains power applied, but no Enable or Run signal applied
 Motor Autotune in progress.
x.x Drive running, display shows output frequency (Hz) Whilst the drive is running, the following displays can be
selected by briefly pressing the button on the drive.
Each press of the button will cycle the display through to the
next selection.
x.x Drive running, display shows motor current (Amps)
x.x Drive Running, display shows motor power (kW)
x.x Drive Running, display shows customer selected units, see
parameters P2-21 and P2-22
 Drive mains power not present, external 24 Volt control power supply present only
 Hardware enable circuit open. External links are required to the STO inputs (terminals 12 and 13) as shown in section 4.7
Connection Diagram
 Parameters reset to factory default settings
 Parameters reset to User default settings
For drive fault code displays, refer to section 15.1
5.5. Keypad Layout and Function – Standard OLED Keypad (IP55 and IP66 Drives)
OLED Display