Xerox WorkCentre M20-M20i-2723 - Manual (Page 110)

Page 7-22 Xerox WorkCentre M20i System Administration Guide
Netwo
rk In
stal
lation Using Inter
net Ser
vices
Raw TCP/IP Printing
Use these instructions to enable or disable Raw Printing using CentreWare Internet Services.
Installation Procedure
There are two stages required to install the device on an Raw TCP/IP printing network using
CentreWare Internet Services:
¾ Configure the WorkCentre M20i
This procedure explains how to use CentreWare Internet Services to
configure the device.
¾ Test Print
A print job should be submitted to ensure the device has been installed and
configured correctly.
Configure the WorkCentre M20i
To complete the installation of the WorkCentre M20i, perform these steps:
¾ Enable CentreWare Internet Services (see “Enabling Internet Services” on page 7-5).
¾ At the CentreWare Internet Services Home Page for the WorkCentre M20i, select the
[Properties] tab.
¾ Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame,
and then select the [+] symbol to the left of the Protocols folder.
¾ Select [Raw TCP/IP Printing].
Select the checkbox to enable Raw TCP/IP Printing.
Enter the [Port Number] and then enter the required port number.
NOTE: While you can change the port number at which the WorkCentre M20i will
accept RAW print jobs, it is recommended that you use the default port, 9100. this is
the industry standard
¾ Click the [Apply] button to implement any changes.
NOTE: Click the [Undo] button to cancel any changes made and return to the
previous values.
1
2
3
4
5