Xerox WorkCentre M20-M20i-2723 - Manual (Page 178)

Page 11-10 Xerox WorkCentre M20i System Administration Guide
Adm
inistr
a
tion
T
ools
Change the Passcode
This procedure is used to change an existing passcode or to enter a passcode after Passcode
Protect has been enabled.
To change the passcode:
¾ Press the [Machine Status] button. 1
2
¾ Press or until System
Admin Tools is displayed and
press [Enter].
¾ If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
System Admin Tools
[Passcode Protect]
3
¾ Press or until Change
Passcode is displayed and press
[Enter].
¾ Enter the existing passcode and
press [Enter].
NOTE: This will be blank if you
have just enabled Passcode
Protection
System Admin Tools
[Change Passcode]
4
¾ Enter the new passcode and
press [Enter].
Enter Passcode: