Xerox WorkCentre M20-M20i-2723 - Manual (Page 72)

Page 5-4 Xerox WorkCentre M20i System Administration Guide
Apple
T
alk
NOTE: The WorkCentre M20i will attach itself to the default zone of the local
segment where it is connected.
¾ Install the Printer Driver (see “Printer Driver Installation (Mac OS 8x,9x only)” on page 5-5).
4
¾ Press or until Network
Setup is displayed and press
[Enter].
System Admin Tools
[Network Setup]
5
¾ Press or until Configure
Network is displayed and press
[Enter].
¾ Press or until Ethertalk
is displayed and press [Enter].
Config. Network
[Ethertalk]
6
¾ To enable or disable Ethertalk,
press or until the
desired setting, [On] or [Off] is
displayed and press [Enter]. Ethertalk
[On]
7