Xerox WorkCentre M20-M20i-2723 - Manual (Page 34)

Page 2-8 Xerox WorkCentre M20i System Administration Guide
Basic N
et
w
ork
Installat
ion
Network Communication Setup
Automatically setting TCP/IP Addresses
At the WorkCentre M20i, perform these steps:
¾ Ensure that the Ethernet Port has been configured (see “Ethernet Port” on page 2-3).
¾ Press the [Machine Status] button.
1
2
3
¾ Press or until System
Admin Tools is displayed and
press [Enter].
¾ If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
System Admin Tools
[Passcode Protect]
4
¾ Press or until Network
Setup is displayed and press
[Enter].
System Admin Tools
[Network Setup]
5
¾ Press or until Configure
Network is displayed and press
[Enter].
Network Setup
[Config. Network]