Xerox WorkCentre M20-M20i-2723 - Manual (Page 52)

Page 3-12 Xerox WorkCentre M20i System Administration Guide
NetWare
IP NDPS Printing
¾ Ensure server(s) and NDS are patched to the correct level.
¾ Ensure that NDPS 2.0 is installed.
¾ Ensure that the latest version of the Xerox NDPS Gateway is installed on the relevant
server.
¾ Ensure that you have an NDS login with sufficient rights to create objects in the desired
container.
NDPS Printing to the WorkCentre M20i can use either IPX or IP. This uses LPR printing
therefore the Line Printer Daemon must be configured. See “Enabling/Disabling LPR/LPD” on
page 6-3.
¾ Create NDPS Printer object:
In NDS create a new NDPS Printer object in the appropriate container.
- Enter a name and select [Create].
- Choose the appropriate NDPS Manager and select the Novell Printer Gateway.
Select [OK].
- You can choose a printer type at this stage if desired. Otherwise leave as None.
Select [OK].
- On the Configure Port Handler screen select [LPR on IP] and then select
[Next].
- Enter the IP Address (or host name if appropriate) of the WorkCentre M20i.
NOTE: The Printer Name can be left at the default.
- Select [Finish]. The new Printer Agent will load on the relevant server.
- You can select print drivers at this point if you wish. Select [Continue] and then
[OK] to finish.
NOTE: The two configurations described above can coexist.
¾ Install the print driver for on each workstation (see “Workstation Setup” on page 4-3).
1
2