Xerox WorkCentre M20-M20i-2723 - Manual (Page 86)

Page 6-8 Xerox WorkCentre M20i System Administration Guide
Advanced TCP
/IP
Set
up
Enabling/Disabling HTTP
This procedure is used to enable or disable Hypertext Transfer Protocol (HTTP) on the
WorkCentre M20i.
To enable HTTP, at the WorkCentre M20i, perform these steps:
¾ Ensure that the basic TCP/IP settings have been made (see “Basic TCP/IP Settings” on
page 2-5).
¾ Press the [Machine Status] button.
1
2
3
¾ Press or until System
Admin Tools is displayed and
press [Enter].
¾ If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
System Admin Tools
[Passcode Protect]
4
¾ Press or until Network
Setup is displayed and press
[Enter].
System Admin Tools
[Network Setup]
5
¾ Press or until Configure
Network is displayed and press
[Enter].
Network Setup
[Config. Network]