Xerox WorkCentre M20-M20i-2723 - Manual (Page 29)

Xerox WorkCentre M20i System Administration Guide Page 2-3
Bas
ic Netw
ork Ins
tallation
Ethernet Port
The Ethernet port is the default interface used on the WorkCentre M20i.
NOTE: The Ethernet port cannot be disabled.
Ethernet Port Setup
If the speed setting of the Ethernet port needs to be changed perform the following steps:
¾ Connect the device to the network outlet or cable.
¾ Press the [Machine Status] button.
1
2
3
¾ Press or until System
Admin Tools is displayed and
press [Enter].
¾ If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
System Admin Tools
[Passcode Protect]
4
¾ Press or until Network
Setup is displayed and press
[Enter].
System Admin Tools
[Network Setup]